Airwrap Cot Mesh 4 Sides - White

Cot Mattress
In stock
Little Linen

The Airwrap Mesh Cot Liner is a cot bumper alternative and is one of the most trusted and popular nursery bedding essentials in Australia since 2006.

Moderately padded to help parents protect their baby from knocks and from tangling in the cot framework.

Air-permeable with vented corners for air to move.

Designed in Australia, the adjustable 4-sides cot liner mesh fits most rectangular cots with rails/slats on both sides and is machine washable


  • Airwrap Cot Liners are INPAA approved (Infant Nursery Products Alliance Australia)
  • Open corners provide ventilation channels for air to move
  • Free from bumper ties
  • Tested to be non-toxic and not produce any VOCs
  • Keeps arms, legs and pacifiers inside the cot
  • Moderate protection against bumps and knocks
  • Provides a visual shield
  • Non-pillowy slimline construction
  • Air-permeable/breathe-through materials (often miscalled 'breathable')
  • Bumper alternative
  • Machine washable
  • Fits most rectangular cots with rails/slats on both sides and has solid ends
  • Contains 4 adjustable cot liner mesh pieces
  • Designed in Australia. Registered Design ®
More Information
Care Instructions
  • 100% Polyester air permeable mesh, polyester and cotton trim.
  • Secure grip tape in place prior to washing to avoid snagging.
  • Cold machine wash on gentle cycle or cold hand wash. Line dry.
  • Trim loose threads if they appear.
  • Do not bleach. Do not dry-clean.
  • Do not iron. KEEP AWAY FROM FIRE.


Remove or do not use if:

  • The fit is sagging
  • Cannot be fitted securely
  • Any of the materials are damaged or rough
  • Can be used as a climbing aid once your child can stand
Awards -


  • Air-permeable polyester mesh technology with a polycotton trim

Product Size:

  • Each pack contains 2 x Side Pieces and 2 x End Pieces to fit most rectangular cots with rails/slats on up to 4 sides.




0 -24 Months

Airwrap Cot Liner Fitting Instructions

  • Place inside cot/crib/cotbed with grip tape facing the slats.
  • Loop end around single slat only, to ensure maximum grip tape contact.
  • Fasten top and bottom grip tape evenly to ensure a firm fit.
  • Pull and do the same at the other end.
  • Ensure cot liner is even on both sides.
  • Tighten by readjusting either end until cot liner is fitted firmly and securely.

    Repeat for all remaining sides

  • The bottom edge of the cot liner should sit just under the surface level of the mattress.
  • Cot liners can provide leverage to little escape artists once they can stand. Even if cot liners can slide down the rails.


The 2 x long pieces are for the long sides of the cot. If fitted correctly cot liner should look as above. 


The 2 x short pieces are for the top and end of the cot. If fitted correctly cot liner should look as above.

We found other products you might like!